Quote:
Originally Posted by BurrNinja
In my point of view it looks as if he used dremmel to chop off half the support. In the first pic you see the whole support with ic tucked behind it, then second you see half of support gone and more ic shown. Not to bad of review, I may end up purchasing this once I get my broken CV shaft replaced.
|
Thanks for pointing that out. That is the lip that I had to trim. However, it wasn't any kind of support. It easily had an inch of sag if I pulled on it. Seemed more like a spacer that the old Stock IC lower housing/support would push up against. And just for clarification purposes, in that pic that is the Radiator that the strip sits under. I carefully pulled that strip away from the radiator so I didn't accidentally nic the rad with my dremel tool!