Mixing and matching is fine as long as it flows. I've always done this with all of my cars to create a more unique combination.
One thing to keep in mind with Carbon Fiber parts that have a big flat surface (e.g. Hood, trunk, roof etc..) is that unless its ultra high quality it will look a bit wavy when you look at it from an angle. i would say 99% of all carbon hoods that ive seen is like this. It doesn't bother some but for me i would not do it on a 70K car. You can still see it after you painted it unless the body shop does some extensive prep work on it. Basically they need to add a skim coat over the entire surface, sand and then primer it to make it all even again.
Alan
Last edited by Alan l.; 02-15-2013 at 01:50 PM..
|