[M_Bimmer]

Posting pictures of the SZL connector wire addition and JBE wire location all to support heated steering wheel mod:

Wire 1:
- Run wire from the Front Fuse Box (JBE), Connector Z1*10B pin 8, Fuse 24 to the Steering Wheel Clockspring (SZL), Connector A92*1B, pin 9 (+12VDC can be taken from other source, so optional)


Wire 2:
- Run wire from the Front Fuse Box (JBE), Connector A34*3B pin 11 to the Steering Wheel Clockspring (SZL), Connector A92*1B, pin 11 (Ground that is FET driven, so this is NOT an optional hookup...must be installed so heating on/off switch works)

The wire diameter to use is 0.75mm^2 which is equivalent to 18 AWG.