Quote:
Originally Posted by Alan l.
I would check to make sure all the connections are still tight. Especially the wires you have to splice into for CANBUS access. Also look at the positive/negative connection to be sure they have a solid clean connection.
Did you also make sure you have the F10 specific firmware? I remember Terry said when you order the jb4 upgrade to make sure you email him to let him know its for a F10.
Alan
|
It's for the F10. The issue might be the CANBUS wires because during install I hand clamped them and then drive around a bit and it worked fine. Then I came home and clamped it with pliers to make sure the clamp closed. That's when the issue came up