Thread: Roof Rack
View Single Post
      07-24-2011, 01:07 PM   #6
jadnashuanh
Major
United_States
50
Rep
1,061
Posts

Drives: 535iGT x-drive; i3 BEV
Join Date: May 2010
Location: USA

iTrader: (0)

It is designed for easy on/off. It comes with a T-handled security torx wrench...one bolt in each end. Just loosen it, lift the thing off, flip the cover back down.

The first time you install it takes a little more time as you need to install a plastic 'bumper' in the bottom of the well under the cover for the rack's feet to sit on (this stays there - this prevents the feet from scratching the paint and helps distribute the load), then, you may need to adjust the width of the support feet so they line up properly with the holes in the roof. Then, you snap in the rubber strip in the slot of the top of the rail.

You'd want to remove it for normal running around and especially on a long trip if it wasn't going to be needed to maximize fuel economy. Plus, they warn you NOT to leave it on through a car-wash. My guess, maybe a couple of minutes to remove - it's just four captive screws that need to be loosened (one on each corner) and it lifts off.
Appreciate 0