Most of the trim panels are clipped in - a bit of force is required, the ones on the boot are particularly hard (a metal trim tool will help).
I did not remove the side cushion - i was a bit worried about breaking it as i could not figure out how it was clipped in, i think its at the top and then pulls up - i Was able to to get my hand in to pull the cable through- there is also a clip hidden in there for the rear door sill trim.
I removed the rear door and front door sill trim, B pillar lower trim loosened it , un-clipped lower part only ( to remove it completely you probably need to remove the seat belt trim. removed the A pillar lower trim and also there is a access panel underneath between the glove box and the front of the car( 3 screws - one is on side near transmission tunnel ). I should say my car is RHD and cable goes down the left had side looking from the rear along with the other cabling - there are already channels there so making a lot easier to pull the cable though.
|