[Davidlt]

Hello,
I havent found any solution at service, at auto electric workshop, so the last thing which I have to decided to do, try to search help at forums.

I get an error message after all start/stop function work, the error is: transmition temperature

Image:

I have changed the gearshift oils and filter yesterday, but error still exist.

-

Any ideas? Need help

[Luky]

Maybe you did not assemble the fluid pickup correctly when replacing the filter/pan? I seem to remember a tube that sticks down from the tranny into the fluid in the pan (maybe that was my E90 though). Sounds like you may need to drop the pan again and check it... (save the fluid to reuse! Stuff is expensive).

[Alexdorosh98]

I had the same problem, faulty dme was the cause, had to replace it.

[Davidlt]

Originally Posted by Alexdorosh98

I had the same problem, faulty dme was the cause, had to replace it.

Have u buy new one or used? And how much it cost for u?

This error I saw when auto start stop is working, when engine is on, no error notice, it was the same for you?

Thanks

[Davidlt]

Originally Posted by Luky

Maybe you did not assemble the fluid pickup correctly when replacing the filter/pan? I seem to remember a tube that sticks down from the tranny into the fluid in the pan (maybe that was my E90 though). Sounds like you may need to drop the pan again and check it... (save the fluid to reuse! Stuff is expensive).

The problem was before changing the oils. This error was a reason to change filter and fluid inside gearbox

[Alexdorosh98]

Originally Posted by Davidlt

Have u buy new one or used? And how much it cost for u?

This error I saw when auto start stop is working, when engine is on, no error notice, it was the same for you?

Thanks

Do you get this message when the engine is still cold? The dealer quoted me $3200 for a new dme, so I went with module experts from Florida for $500, the dme was plug and play.

[Davidlt]

Originally Posted by Alexdorosh98

Do you get this message when the engine is still cold? The dealer quoted me $3200 for a new dme, so I went with module experts from Florida for $500, the dme was plug and play.

The problem is when engine is hot and start / stop function is working

When engine is start no error message, when i stop near the cross and engine will stop, i saw an error, when i start the engine again i saw no error

Ye, the problem is when engine is hot