[ElPafko]

Hi y'all,

I've got some problems with Dynamic Damping Control.
Car is F11 535 xd


Mechanic changed wheels. Shortly after at one time I've got "Cornering ability restricted" on the dashboard and "Dynamic Damping Control failure" on center screen. This looked like it happened randomly when changing from drive to reverse. Error persisted for half a day until I drove through a small bump and error disappeared.

However this error would occur occasionally I would say at random times and would instantly disappear (you would hear infamous bmw chime and error would appear on the screen).

Currently this error seems to be permanent and it does not disappear. This locks out different adaptive drive modes (only comfort is mode is available).

Today I've checked active errors and found these:



Central Gateway Module
2 errors
801C60: Flexray autolearn not ok
801C20: Central fault memory full

Vertical Dynamics Management
1 error
D754F0: Message (2.0.1, status bike node HR): not received

Damper satellite, rear left
1 error
F2EC06: FlexRay signal error - state road

Integrated automatic heating / air conditioning system
1 error
8011BB: Stratification potentiometer on the right: short circuit to plus or interruption

Damper satellite, front left
1 error
F26C06: FlexRay signal error - state road

Damper satellite, front right
1 error
F2AC06: FlexRay signal error - state road


It's interesting how three damper satellites are showing errors. Anyone have any ideas what could be happening there?