|
|
03-17-2023, 07:02 AM | #1 |
New Member
0
Rep 6
Posts |
Retrofit OEM alarm
I retrofitted the alarm on my 2015 BMW F11 car but now I have a problem detecting the ECU, when I run ISTA it shows ECU FZD
But when I run esys the ECU FZD does not appear attachment: error in ISTA does anyone know the solution thanks |
03-18-2023, 12:19 AM | #2 |
Captain
583
Rep 831
Posts |
Can you provide a bit more information?
Did you change the FZD (A21) from a basic to a "high version"? Did you install the alarm horn (H1) in the right rear bumper area? Did you run the LIN Bus wire from the H1 to the FZD? Did you code S145A option into your FA? What does ISTA list as your error code for the FZD module? |
Appreciate
0
|
03-20-2023, 11:36 AM | #3 | |
New Member
0
Rep 6
Posts |
Quote:
|
|
Appreciate
0
|
03-20-2023, 09:56 PM | #4 |
Captain
583
Rep 831
Posts |
The diagram on page 9 of your installation manual doesn't look like your retrofitted alarm interfaces the FZD module, only the CAS.
This means your issue with the FZD in ISTA, is independent of your alarm wiring. On page 13 of the installation manual, it does show removal of your FZD module to route your alarm wire to your rearview mirror. I would recommend that if you did pull the FZD module, to remove it, and try to reseat all the connectors. It looks like the connector that has the bus wires isn't plugged all the way in. |
Appreciate
0
|
03-22-2023, 06:33 PM | #5 |
New Member
0
Rep 6
Posts |
hello M_Bimmer
I only had the opportunity today to remove the FDZ module and I verified that the A21*2B connector does not have the CAN wires that connect pins 9 and 10. I will have to make this connection between connector A21*2B and connector A16*1B. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|