[2013F10]

I have the comfort seats with ventilation/heat/massage, and my driver seat massager function stopped working. When I push the massage button it lights up, after a few seconds you can JUST feel one of the massage bags filling, then it stops and the light goes off. Everything else on the seat works.

I have since swapped the seat modules with the passenger seat and the issue followed the module.

Is there a way to reset the seat module for this? I have ISTA D/P and Esys, although I have not used Esys before.

[Hoa]

Run ISTA to see if there is an error code. Seat modules are cheap so you can swap them out if they have a problem and then recode it your your vehicle with ESYS

[2013F10]

Originally Posted by Hoa

Run ISTA to see if there is an error code. Seat modules are cheap so you can swap them out if they have a problem and then recode it your your vehicle with ESYS

Thank you for suggesting this. I began troubleshooting before I had ISTA and was stuck on it being the seat module. ISTA pulled a 802BB7 code, which is active seat cam motor (pressure distributor) short circuit or interruption. I found a used active seat setup on eBay and will swap out the pressure distributor.