|
|
|
2010 2011 BMW 5 Series Forum F10 3d front bumper lip spoiler install |
|
Post Reply |
|
Thread Tools | Search this Thread |
06-16-2016, 01:24 PM | #1 |
Captain
60
Rep 627
Posts |
3d front bumper lip spoiler install
Just got my 3d spoiler painted and am prepping for install.
For additional insurance beyond the double sided tape I was thinking of adding some screws on the bottom of the lip. Any others who went this route? Also, there are two holes drilled on each side where the lip wraps around the wheel well. It seems like the only place for screws to go would be into the fender liners but I have not done a true mock-up yet. Is that correct? |
06-16-2016, 02:44 PM | #2 | |
General
1568
Rep 29,202
Posts |
Quote:
I didn't do additional screws under the lip.
__________________
F10 520d M-Sport Alpine White | HRE P43SC 20x9+20x11 | Michelin PSS 255/35+295/30 | KW V3 Coilover | M5 Front Sway Bar + M550d Rear Sway Bar | 3DDesign Front Lip | BMW M Performance CF Spoiler | BMW M Performance Diffuser | BMW M Performance Black Grills | BMW M Performance Pedals | |
|
Appreciate
0
|
06-16-2016, 06:10 PM | #4 |
Lieutenant General
9156
Rep 14,522
Posts |
Not sure if you have the non m or the Msport but you can see here on my non m 3d carbon fiber spoiler I did put a bolt on each end. I still have yet painted them black so they don't stand out so much. I also attached several bolts from underneath as well. So far it's held up well
__________________
~F90Conversion~21"3Piece Forged AvantGardeWheels~KWV1Coilovers~CQUENCE slotted/drilled rotors~GoodridgeStainlesslines~MeisterschaftQuadEx haust~Akrapovic 4"tips~VRSF DP~VRSF CP~TurboSmart BOV~K&N filter~CarbonFiberExteriorComponents~GladenAlphaCo mponents~MatchUp7BMW~Punch P300-12T~ Follow me on Instagram: lsturbointeg |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|