|
|
|
2010 2011 BMW 5 Series Forum F10 BMS CAN Tool for F10 - anyone have the firmware files |
|
Post Reply |
|
Thread Tools | Search this Thread |
07-15-2016, 08:07 AM | #1 |
Colonel
355
Rep 2,080
Posts |
BMS CAN Tool for F10 - anyone have the firmware files
Hey fellas,
Does anyone have the F10 firmware files for the BMS CAN Tool you can send my way? If so, it'd be much appreciated. Drop me a PM. Thanks in advance. |
07-15-2016, 03:26 PM | #2 |
Captain
245
Rep 785
Posts |
There are no firmware files. The only thing the can tool does for the F10 is clear CEL from catless downpipes
You plug it in and the CEL goes away after a few minutes |
Appreciate
1
BoogieMan212.50 |
07-24-2016, 08:14 PM | #3 | |
Colonel
355
Rep 2,080
Posts |
Quote:
http://stuff.is-a-geek.net/OnlineDoc...MW/CANtool.pdf See the last section |
|
Appreciate
0
|
07-27-2016, 12:44 AM | #4 | |
Captain
245
Rep 785
Posts |
Quote:
I've spoke with a representative and they're very conservative with any information about the CAN Tool, however they confirmed that there were not any FW updates to the CAN tool. There's also a legacy CAN tool support thread over at North American motoring where the forum members discuss that there were no firmware updates. That, and there would probably be multiple support threads about it all over the different bimmer native forums. The CAN tool does not hijack gauges on the F10, never has and never will. Unless someone hacks the software and gets it to work. All it does it stop the CEL from DP's. It doesn't respond to anything either, you plug it in and wait a few minutes until the CEL disappears. I have one from 2014 and that's what I use it for. Last edited by SLVSRFR; 07-27-2016 at 12:52 AM.. |
|
Appreciate
1
BoogieMan212.50 |
Post Reply |
Bookmarks |
|
|