|
|
|
2010 2011 BMW 5 Series Forum F10 Dinan springs install question |
|
Post Reply |
|
Thread Tools | Search this Thread |
01-19-2013, 04:29 PM | #1 |
Lieutenant
86
Rep 459
Posts |
Dinan springs install question
I recently installed dinan springs and after two weeks and an alignment. I realized that both passenger front and rear sits 20mm lower than the drivers. Did they install it bad or something is wrong with my car? thank you
|
01-26-2013, 10:44 AM | #2 |
2013 550i xDrive MSport, carbon black
0
Rep 2
Posts |
Dinan springs on my 550 xDrive: left and right side match. The Dinan upgrade dropped it from a loose three finger gap all around (50mm +) to a tight two finger gap in the front (about 35mm) and a slightly tighter two finger gap at both rear fenders.
|
Appreciate
0
|
01-26-2013, 02:56 PM | #3 |
Lieutenant
86
Rep 459
Posts |
Can you do a favor for me and measure the height from the floor to the lower part of the fender?
My front right is 27 1/4 Front left is 28" Rear right and left are 27 1/2" I've contacted dinan and they've said my front right is a bit on the lower side and 28" is where it's suppose to be at. But stock is 28 1/4". Thanks for your reply. |
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|