[Avo2go]

Hi all,

Have a f11 2011, was doing about 60 and idrive popped up saying transmission issue or something and car went into limp mode. Stopped and tried to restart but the whole car began to shake and not possible to drive. After a few times it would not start at all.

AA outsourced to a local recovery flatbed vehicle and gave me a courtesy car, now I have no idea when I will get the car back but wondered if you guys could help me understand what went wrong. The AA guy emailed the below, anyone have an idea of what went wrong/what sort of garage to take it too/how much it might cost when they deliver it back?

many thanks in advance for any advice.

Patrol found the following fault code/s:System : Engine control 1 - VE0 / Diesel EDC 17 UDS24F700 - Fuel filter heating. Error Message : Open circuit.25C800 - Exhaust gas pressure sensor. Error Message : Drift detected.245700 - Particulate filter system. Error Message : Faulty.247500 - Rail: Plausibility pressure. Error Message : Value outside range.247600 - Rail: Plausibility pressure. Error Message : Minimum pressure too low.248600 - Rail: Plausibility pressure. Error Message : Pressure too low.249300 - Fuel high-pressure monitoring (Rail). Error Message : Pressure too low on starting.We have arranged for a recovery of your vehicle.Cut out non start. Arrange recovery to home address.

[Mechfan]

Hello!
Try this to resolve 25C800 and 245400. This is my post and I hope Google can translate it correctly. This OEM 13627805152 sensor has been installed in many BMW diesel engines.
https://www.drive2.ru/l/650604120972986106/