|
|
12-13-2016, 06:32 PM | #1 |
Enlisted Member
19
Rep 33
Posts |
Brake pad sensor wire?
I need a little advice/help. I am in the middle of a DIY rear brake pad replacement (first time doing any pad replacement) & got the job done on the left rear. Everything seems to have gone smooth. I am now doing the right rear but have run into a small snag. I can not figure out how to open the brake pad sensor control box to unplug the sensor. Can anyone give me any tips on how to get the control box open so I can unplug the sensor? Thanks
Last edited by trevor56; 12-13-2016 at 08:09 PM.. |
12-14-2016, 08:32 PM | #2 |
Major
612
Rep 1,254
Posts |
I do all my brake jobs I never did brakes on F10 you should be able to just open box and unplug sensor
I guess question is why are you replacing sensor did it get damaged? if not I wouldn't replaced it.
__________________
|
Appreciate
0
|
12-14-2016, 08:53 PM | #3 |
Enlisted Member
19
Rep 33
Posts |
Thanks for the reply. I finished the job earlier today. I was working in a poorly lit garage last night but when I started back today in the daylight I could see how to open the control box. The wear sensor had been triggered so I had to replace it. Everything went smooth.
|
Appreciate
0
|
12-14-2016, 09:46 PM | #4 | |
Major
612
Rep 1,254
Posts |
Quote:
Sweet, its good feeling when you DIY and save money at same time
__________________
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|