Quote:
Originally Posted by cm048
According to BMW ISTA/D this is the procedure to remove/ install front seat of BMW F10.
Move front seat rearwards.
Release screws (1).
Installation note:
Replace screws.
Tightening torque 52 10 01AZ. 1AZ Seat to floor panel F01 / F02 / F03 / F04 / F07 / F10 / F11 / F18 M 10 (trilobular) Replace Powerlock screw (self-locking) 43 Nm This means that once you remove the seat bolts, you can not reuse it. It is powerlock screw, one time use only. Tighten torque is 43 NM.
Part number for the screw is 07149156953, total of 8 for two front seats.
I already order the screws with BMW, less than $2 each.
Need to wait for screws for about a week.
|
Where did you find a TIS manual for the F10? PM me how to obtain please.