Hi there,
I've recently bought a 2016 F10 520d M Sport and there are a few issues with both the front and back bumpers which I would like to fix if at all possible without buying new bumpers.
The first issue is with the back bumper, just below the bottom edge of the boot lid. As you can see from the two images, there is no gap between the top of the bumper and the bottom of the boot lid edge, which has caused the boot lid paint to be completely rubbed off in two places and therefore, rusting might be an issue in the future. There is a tow bar fitted so the bumper was definitely removed at some point but it is lining up everywhere else so it doesn't seem that it's out of place. Any suggestions?
The second issue is with the front bumper, where the side of the bumper meets the side fender. There is a big gap between the bumper and the fender and they also don't line up properly which looks bad. There is damage to the underside of the bumper on the same side so it looks like it was previously driven onto a kerb and it pulled off a bit. Is this something that could be adjusted better?
Thanks!