Here's my last run with D Shoup. It looks roughly like over 380 whp with these calculations.
442 ft-lb @ 5356Rpm
Look at torque act.clutch nm
https://datazap.me/u/bmwdoubles/run-...8;data=3-14-23
Then convert nm to torque
https://www.metric-conversions.org/e...oot-pounds.htm
Then calculate using rpm and torque
https://spicerparts.com/calculators/...que-calculator
Then multiply 15% drivetrain loss, take that number and minus it from the hp to get your real whp.
Grant it these are very rough estimates without a dyno. It's ok with 17 PSI. Let's see if I can hit this 550whp mark.
We're working on getting power down low since the manual and my hardware is laggy down there.
I'm currently as a fast as a 550i stock or an e90 M3 stock in regard to numbers obviously a time slip will be the real truth or a lap time. Keep in mind I didn't rev this thing all the way out so I could actually be clearing 400whp. There's some hesitation at the top we're also working out so I'll wait to we have that cleared.
I need to crush those 5.0's on track