Quote:
Originally Posted by trjn
Yes. It was the module that was bad. Finally I ordered one from 2013 550i which had the same seats (comfort, heat, memory, no ventilation or massage). Hardware was plug and play. And once I coded the module to my car via esys, the airbag light went away.
|
Hey bro please hear me out with my problem. F06 640i GC, i retrofitted comfort seats (just needed power to pin 1), all was well until a thin drinks can popped under my seat squirting liquid out slowly - i later take the seat out to clean, reinstall,and then i lose power movement to my passenger seat - but heating and lumbar works.
Ista said its a problem with the lin bus in the seat. So i replaced the seat wiring loom (£200)... problem still the same. Before this i had swapped switch blocks and modules with the driver side, same problem exists.
Any ideas at all?! Ive visually checked fuses but not with a multi meter, they appeared intact.