Quote:
Originally Posted by idog
Yeah, I'm measuring right now, but your F10 readings weren't the same as the F10 paddles I have here, the ones I have here are paddles from an F10 535i.
The -paddle
Off : 5.3kohm
On : 1.283kohm
The +paddle did match : 5.3kohm off and 2.297kohm on.
Anyway, I read your message wrong the first time. You said you were going to source SMD resistors in the right values. I read that as - get the same resistors that are now on the F10 paddles. Of course, you meant getting resistors to achieve the same off/on values as the F10 paddles are measuring.  My bad. Now ordered again. It's a good thing these smd's are cheap 
Edit : I stand corrected. Your measurements were on point. I'm an ass and measured the testpoints instead of the cable. Hence my bad reading for the - paddle. They work ! So thank you ! |
Hello mate. Getting a bit lost with the resistors here. Can you confirm what resistors you used and that they were soldered in place as you showed in your previous picture? Did you use the same resistors as shown on the original f10 paddles or did you use resistors of a different value?