Quote:
Originally Posted by Surly73
The simplified process:
1/ bleed a little through all four corners
2/ open LR - ISTA will pre-bleed (large quantity, fast)
3/ open LF - ISTA will pre-bleed (large quantity, fast)
4/ open all four in sequence - ISTA will bleed each one in turn (90s each, modest quantity of fluid)
|
I am to do this soon.
So basically attach the motif, pressure it, load up ISTA, go to the brake bleeding procedure, start - and just follow instructions on screen - clicking next continue as you go along?
On the part 4, where you say open all four in sequence, do you not close the valve before going to the next one? or they all left open at this point?