Quote:
Originally Posted by ezaircon4jc
THANKS! Can you post a pic of how you routed the lines at the intake side? Specifically, how you crossed the lines in the limited space.
|
I'll take a picture tomorrow and post it. It was a bit easier for me because I used 1/2" ID tubing for most of the run. This is because I had to step down from 3/4" ID to 1/2" ID, and vice versa for the return line. The catch can I got only has 1/2" barbs, and I couldn't find 3/4" barbs with the correct threading. I doubt the little bit of restriction is gonna be an issue though.