[babba]

Anybody done this?

Today I reversed into a bush and it has broken the rear RHS outer cluster (well I know technically it was my stupid fault, but I am sure the bush jumped out on me ). I know I can source one, just wondering how I go about replacing it.

If anyone has experience of doing it or knows of a source (knowledge etc.) then I would very much appreciate the help.

Regards

Steve

[Hoa]

It's fairly simple.

1. Remove plastic trim in the middle

2. Rmove trunk lining on the side of your damaged tail light

3. Disconnect plug to tail light

4. Remove 3 nuts for tail light

5. Pull tail light housing out

[babba]

Thanks for the help, found a great video on YouTube. Should have said it was an F11. Seems that all you have to do is open a little plastic tab and remove two nuts. Unit then pulls out, disconnect wire header, reconnect on new unit and replace nuts and cover.