[Double Nickel]

Originally Posted by Blue Angel

Your fronts might need a spacer to clear the suspension upright. Your rears are going to poke by as much as 20mm unless you go stancenation with negative camber and/or super stretched tires.

I got the H&R VTFcoils hope front clear, and my car is not xdrive if that makes a difference. still dont know bout front tires but im going triple nickel g2 305/30/20 in the back.

[brad850csi]

Originally Posted by Double Nickel

19×9.5 +35f/ 20×10.5 +22R Artisa Elder, but look at that fittment with the stock winters tho. Idk What tire size yet,

I'm thinking 265 or 275 is what you'll need to run on the rear, then either 20 or 30mm narrower on the front to match the stretch. Keen to see the end result!

[Double Nickel]

Originally Posted by brad850csi

I'm thinking 265 or 275 is what you'll need to run on the rear, then either 20 or 30mm narrower on the front to match the stretch. Keen to see the end result!

Why not a 295 or 305 Nitto g2?

[zener]

Originally Posted by Blue Angel

So rear is 20x11 ET37 + 5mm spacer? 11" wheel effectively ET32, the wheel might be touching the fender if the tire doesn't! Good luck!

This is without spacer. Tire clears easily and wheel by just. But I'm not going that low... Just tested it with lift.

[Blue Angel]

Nice! I think the 5mm spacer would make it touch for sure.

On your fronts, is it ET37 including the 17mm spacer, or ET20 including the spacer?

[zener]

Et20 with spacer.

[brad850csi]

Originally Posted by Double Nickel

Why not a 295 or 305 Nitto g2?

People running 34mm offset rear wheels can barely get 295mm tyres on there so a 20mm offset wheel will mean you'll need to go down to about a 265 or so. A 295 or 305 will absolutely not fit

[Double Nickel]

Originally Posted by brad850csi

People running 34mm offset rear wheels can barely get 295mm tyres on there so a 20mm offset wheel will mean you'll need to go down to about a 265 or so. A 295 or 305 will absolutely not fit

Challenge accepted

[Blue Angel]

Originally Posted by Double Nickel

Challenge accepted

Allrighty then, 305 on ET20, let’s see it!

[lucasfaria1994]

Hey guys, my BMW F11 2011 (520 diesel, RWD) with 20 inch wheels. Stock height, factory spec tyres. The rear sits flush, the front could use with a 5mm spacer.

(Sorry for European measurements)

Specs:

Wheels: Aversus Kasia
Front: 245/35R20 20x9 ET35
Rear: 275/30R20 20x10.5 ET42