[uas66]

Hi all,

I am planning to retrofit my car with electric rear sunshade. I have a couple of questions, hope you could help me.

I searched on the internet and found out that I need to replace the rear shelf with the motor. Also I need to replace the swich on the drivers side door panel with the shade button.

• The sunshade has 2 wires to the motor. Where do I connect the 2 wires from the motor to? To the switch or some module?
  
• Do I need to code something after installing it, or will it work without coding?
  
• Are there any fuses that I need to install?

Thanks in advance!

[addy27]

Check up on Newtis.info for wiring diagrams. That should give you all that you need

[uas66]

Yes I looked on Newtis. I found out the wiring diagram.

I need to add 2 pins to the JBE, connector A34*1B, pin 3 and 30. My question is if I can use my own JBE or do I also need to replace this module? My JBE number: 61359286941-03.

[addy27]

Pretty sure you should be able to use your JBE just might need to code it using ESYS.

[uas66]

The strange thing is that I can not find my JBE (61359286941) on the listing here:
http://bmwfans.info/parts-catalog/F1...c_3/#9267455_1

So I am not sure if the JBE is compatible with S415A (Sun-blind, rear.)

[Vale70]

Hello!! Were you able to finally complete the brico ? I have found an electric curtain and would like to do it. I think my tray would serve me I would only have to trim the hole for the curtain that I do not know if it comes premarked behind the tray itself. A greeting

[RJV3]

Definitely interested in seeing the final product. How much were all the parts and where did you pick them up from?

[addy27]

Was this completed? OP any feedback on where you connected?

[uas66]

Originally Posted by addy27

Was this completed? OP any feedback on where you connected?

No, not completed yet. I am not sure if the JBE module is compatible with S415A (Sun-blind, rear). So if also the JBE needs to be replaced I think it is not worth retrofitting.