[ChaOZ]

Anybody got any idea why after installing the Fuel-IT Flex fuel kit for my car when I turn it on the engine will start sputtering and eventually die. It will run for a bit I can accelerate and it will hold RPMs but when I let off its almost like it just runs out of fuel. *Note* I am also running the walbro 450 on my setup and have already ran it for a couple of days before I did the flex fuel kit and it worked flawlessly. Some of the codes that I get are ;

-DME Active Codes-

-CDB204 FA CAN message, (outside temperature, 0x2CA) missing

-10B104 outside temperature sensor signal: CAN message in error


-*DME Shadow(Inactive) Codes-

-11A301 - High Fuel Pressure after engine shutdown: Pressure too high.

-11A401- Fuel high pressure during fuel injection release: Pressure too low

-11B401 - Fuel high pressure or after enabling injection (2nd ambient condition set after delay): Pressure too low

[BimmerHausPerformance]

Sounds like you need to talk to the manufacture. Those messages from CAN are from a different ECU that I would think, have nothing to do with your fuel set up.