|
|
|
2010 2011 BMW 5 Series Forum F10 Coding issues replacement CHAMP2 unit |
|
Post Reply |
|
Thread Tools | Search this Thread |
10-18-2023, 08:11 AM | #1 |
New Member
0
Rep 7
Posts |
Coding issues replacement CHAMP2 unit
Hi,
I'm helping a friend with what was diagnosed as a failed CHAMP2 unit. We picked one up at a breakers from a working car. When trying to code it to his vehicle we're getting the attached errors. His current istep is F010-11-03-511. I've downloaded and tested the coding with various versions of E-Sys and psdzdata, the current versions I have installed are 3.29 and 4.37.31. These are the steps I'm following to code the used unit. Connect => Read FA (VO) => Activate FA (VO) => Read SVT (VCM) => Left-Click on desired ECU => Click on "Detect CAF for SWE" => Select the CAFD from latest I-Level shown => Select OK => Right-Click on ECU (the ECU itself not the underlying CAFD) => Select CODE. I'm attaching the log output from esys from where I attempted to code the CHAMP2 , and also where I attempted to code the MULF. Some of the errors are similar so hopefully someone can shed some light. I've only got experience on coding E92/E46 so Esys is a little bit of a learning curve. If it turns out to be a failed MULF that's causing an issue I think I have a spare, or at least a MOST terminator if I need to code it out. Appreciate any help! Last edited by rztt6; 10-18-2023 at 12:02 PM.. |
10-26-2023, 06:27 AM | #5 |
New Member
0
Rep 7
Posts |
I'm using the ENET cable, connecting through Gateway afaik (VIN Connection in Esys and then chose F10 (not selecting the direct option).
I'm not using any loader as my understanding is not required if default coding a component. The full VIN is WBAFW12020C729009 |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|