|
|
|
2010 2011 BMW 5 Series Forum F10 Nbt Retrofit Pre Lci problems (SOLVED) |
|
Post Reply |
|
Thread Tools | Search this Thread |
09-01-2018, 08:13 AM | #1 |
Private
0
Rep 59
Posts |
Nbt Retrofit Pre Lci problems (SOLVED)
I have purchased a Nbt unit to put in my 530D Pre Lci, it is now Cic in it.
I have bought everything i need, included Pre Lci adapter simulator from Bimmerretrofit. I installed the unit in my car as the instructions told med, and activated the adapter. but it seems like Bimmerretrofit sent me Audi Cables for the Fibre optic. Anyway, i decided to try an install it and i thought i would fix the Fibre optic termination later. Then i start the unit, it says Connected drive on the screen and then it goes black again. Is this because i haven't yet terminated the most or is it because i haven't coded it yet? Last edited by HaugF30; 09-10-2018 at 06:47 AM.. |
09-08-2018, 09:33 PM | #2 |
New Member
0
Rep 5
Posts |
I had the same issue until I disconnected my zgw and terminated most fiber. It seems that NBT Evo does not work with zgw. Someone from their tech support explained that I need to have that optical cable removed and terminated for correct functioning. Hope yours is resolved too.
|
Appreciate
0
|
09-09-2018, 05:53 AM | #3 |
Private
0
Rep 59
Posts |
Yes it is resolved now, it was the right cables but it did have some transportation security plugs in them i had to remove, it didn't say so in the instructions.
They have now updated the instructions. Now i'm struggling with the rearview camera, i got image, but it is distorted. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|