[HaugF30]

Anyone know if i need to rewire the camera wires then going from CIC HU to NBT HU?

There are 3 wires in the car Quadlock red wire at Pin 18, Black at pin 27 and white at Pin 28, then i put the car in reverse i get a image, but it is distorted.

I can see that Pin 18 on Nbt Pinout diagram is Mic2 (+) and Pin 27 is FBAS (-) Baseplate and Pin 28 is FBAS (+) Baseplate.

But i'm not sure what the Red, White and Black wires are excactly, cause i can't find CIC pinout diagram.

But are there anyone who has gone from Cic to NBT and needed to rewire?

[HaugF30]

I will answer myself here

Black FBAS Shield (Baseplate) Pin 26
White FBAS (-) (Baseplate) Pin 27
Red FBAS (+) (Baseplate) Pin 28

[Celo27]

So you mean that the pin should be gone from to:

black pin 27 --> Black FBAS Shield (Baseplate) Pin 26
white Pin 28 --> White FBAS (-) (Baseplate) Pin 27
red wire pin 18 --> Red FBAS (+) (Baseplate) Pin 28

or did i miss understood it?